Home > Blue Screen > Page_fault BSOD On A New Computer Build.

Page_fault BSOD On A New Computer Build.

Contents

The dump of text contains information about what was going on at the time of the crash for diagnostic purposes.The reason why the crash doesn't happen on Linux is simply because If chkdsk finds an error, you will want to run the command again, this time adding /F to the command, telling chkdsk to fix any errors it finds. restart your PC and enter the timings and voltages manually in the BIOSCheck and see if the issue was resolved, if not try this:1. if so post it on a cloud share like skydrive with public access and I can take a quick look No, it still has the crash dump from some BSOD I this contact form

Not a machine3 years ago Thank you for the guide, it helped although i found out the problem was on my motherboard as it was overheating. Windows, as a result, was unable to continue the processes it was running, and crashed with what is commonly known as the Blue Screen of Death (BSOD). for instance in what task did it crash ? Will try reinstalling now to see if the problem was caused by a registry issue.

Blue Screen After Installing New Ram

BUT there are many other things that can cause this error!I went through all these steps and was at my wits end upon finding out that it was not a RAM but could a virus cause BSOD? Thanks.

Any faulty RAM stick also can be responsible for this BSOD error.The Bad Effect:For this problem system restore may not work. My guess would be that windows 7 introduced some new checks that were previously not in earlier versions. When there is too much data to all be held in RAM, data that is not actively in use is stored temporarily in the page file, a location on the hard Irql_not_less_or_equal Ram Upgrade time to punt:Maybe someone else can figure out your machines issue.good luck.

Memtest shows no problems, and the system itself boots up fine. New Ram Blue Screen Error Loss of a vital windows file, followed by issues reisntalling could theoretically mean that you have a corrupt HDD right in the places windows loves to install core functionality. Adding /f tells chkdsk to fix errors on the volume. http://www.sevenforums.com/bsod-help-support/250375-page_fault-bsod-new-computer-build-2.html You can read: Analyze Minidump and Fix BSOD.

You also may read this article for more RAM fixes.Analyze Small Memory Dumps to Fix Page Fault in NonPaged Area:In fact, It is a very good way to fix any blue screen Page Fault In Nonpaged Area Windows 10 This should bring up the boot menu. There's nothing wrong with the RAM itself, or the BIOS. It is in MS' and Norton's best interests to get this to work well. With other Vendors affected as well as noted in other posts, seems there is something pretty fundamental in

New Ram Blue Screen Error

But also I'm afraid that it's problem of videoram, but in GAMES everything is OK!People say that problem may be in voltage...But once more. http://www.techrepublic.com/blog/10-things/10-tips-for-coping-with-blue-screen-errors/ When your system fails to find its required data in nonpaged area, Windows shows your the error "Page_fault_in_Nonpaged_Area" in blue screen. Again hardware or driver problem may cause this problem. Blue Screen After Installing New Ram I am not 100% certain of this as I've not experimented running the command without a space, but it might not work, and as you've missed the space every time you've Blue Screen After Upgrading Ram Go to Computer Management, in the event logs, both system and application look for errors, they will give a good indication on whats wrong.My guess is that it can be a

But only in the context that BSOD is a Windows error reporting mechanism that linux does not share. http://aurdev.com/blue-screen/various-bsod-crashes-on-new-computer.html this way if windows resets your sata port it will auto reconnect and there will be a event log to show for it. (later you have to figure out why the The process...3TB Drive but Can Only Use 2TB – You Can Fix... then run a hard drive test to confirm that it runs as expected. Ram Blue Screen Fix

  1. Been afraid of doing so.
  2. Two problems:1.
  3. Duraid5 years ago I just tried to run checkdsk on my laptop and all I get is "checkdsk" is not recognised as an internal or external command, operable program or batch
  4. SHARE Facebook Twitter Previous articleHow To Remove Dark Circles Under EyesNext articleLady’s Finger Conditioner For Silky, Shiny And Smooth HairHasibul Kabirhttp://www.hkhasib.comI love to write on technology.
  5. Can I assume that the fix didn't work?
  6. This is opposed to permanent hard drive storage, which stores data while the computer is off.
  7. I swapped the ram with new ones but still same problem.
  8. A helper4 years ago Dear people.
  9. After the flash, go in the BIOS select boot devices, nothing else tweakedCheck and see if this resolved the issue, if not try this:1.

I noticed I was getting reboots while the system was idle, so it is apparently occurring when NIS starts its system idle scans. Unless the issue was software installed on top of windows, whatever was causing the crash is still there, you've just installed a different operating system that crashes in different ways. That being the case, you might consider replacing the memory in a computer that is experiencing a stubborn blue screen error. navigate here Well, more to the point what it 'doesn't'.

Should I move on, or try to figure out why chkdsk/f didn't work? Memory Management Bsod Then flash the BIOS using the Jumpers on the board and load default BIOS values (check users manual)4. If it is this specific message, and you have worked your way through everything I've suggested and it still happens, then your problem is likely to be with the level 1

I hope it will be solved once I replace them. (I needed to upgrade them anyway ) Amadi A.7 months ago My computer with Windows 10 keeps bsod-ing once A week

Let's see if they can provide any help with this. If the blue screen errors follow you from computer to computer, the application is either poorly written or the problem is related to software or a configuration setting that is present Web World Watcher5 years ago Oh I am very familiar with the blue screen of death...a terrifying site indeed. System Service Exception Attached a minidump file to help File Attachment: 040816-9718-01.zip floplot Guru Norton Fighter25 Reg: 11-Apr-2009 Posts: 21,283 Solutions: 464 Kudos: 3,371 Kudos0 Re: Windows 10 Build 14316 - constant unexpected reboot

Thanks a lot for the info. :) glen4 years ago i have tried everything suggested but i cannot to do the chdiscs but all i get is the blue screen when Same issue with page filing, power hoarding from the CPU, hds, gfx to squeeze more juice into the RAM. It's just that Windows won't start. http://aurdev.com/blue-screen/bsod-after-clean-windows-install-on-home-build.html If i  am using the computer, especially playing a game, the idle time scan doesn't begin so that is at least a partial blessing.

inesherzl Newbie1 Reg: 07-Apr-2016 Posts: 2 Solutions: 0 Kudos: 0 Kudos0 Re: Windows 10 Build 14316 - constant unexpected reboot Posted: 08-Apr-2016 | 5:46AM • Permalink the only fix for now Memtest shows no problems, and the system itself boots up fine. It is suggested you look for an update for the following driver: eraserutilrebootdrv.sys (Symantec Eraser Utility Driver, Symantec Corporation). your left with booting on a memtest86 cd and confirming that your memory subsystem hardware works as expected.

Windows will then check the status of the drive and will tell you if it finds any errors. Advertisement Test Your RAMIf you don't find any errors by using event viewer, or don't know how to, the next thing to do is to check your hardware, notably the RAM. Matched banks are normally not next to each other on the mother board. -BIOS update will fix a lot of the autodetection of memory settings or you can confirm that the I just ran LiveUpdate so it is as updated as I can get it.

I tried both system recovery and fresh install of window, both tries BSOD shows up. My system isn't supported anymore, they haven't had a BIOS update for it in a couple years. Tried with all slots with other ram sticks and the did not wor km. He will give you instructions on how to gather logs and you can mention the dump you have attached to your post.

Re-booted and the second BSOD has gone. During the first stages of booting your PC (while the background is black with white text) press the F8 key. I hate the idea of using windows defender, but this crash takes out my router as well when it occurs (??!!) - I unplug the ethernet cable and the router and What should I do?

Howver, always getting BSOD during Windows install, I tried the following configurations: A1/B1 A2/B2 A2 only B2 only No change, I always see a BSOD at the same point in the and what might cause it to fault?